Description
Like the TTW1®, the TTW2® model is also power vented but offers higher BTU/Hr. inputs, additional insulation and larger gallon capacities. The TTW2® also offers greater installation flexibility with the ability to vent through a wall or roof, with either 3 or 4 PVC, ABS or CPVC pipe.
Features:
Powerful Blower Motor – Our significantly quiet design has greater resistance to outside winds and the power to vent in many difficult venting situations.
Factory Installed Hydrojet®2 Total Performance System – Cold water inlet sediment reducing device helps prevent sediment build up in tank. Increases hour delivery of hot water while minimizing temperature build up at top of tank.
Vitraglas® Lining – Bradford White tanks are lined with an exclusively engineered enamel formula that provides superior tank protection from the highly corrosive effects of hot water. This formula (Vitraglas®) is fused to the steel surface by firing at a temperature of over 1600° F.
Honeywell Self Diagnostic Electronic Gas Control – Intelligent gas control with spark to pilot ignition system eliminates the constant burning pilot. This results in savings of pilot gas during stand by periods (120 V.A.C.).
Enhanced Performance – Proprietary algorithms provide enhanced Hour Delivery ratings and tighter temperature differentials.
Advanced Temperature Control System – Microprocessor constantly monitors and controls burner operation to maintain accurate and consistent water temperature levels.
Intelligent Diagnostics – An exclusive green LED light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting.
Pilot On Indication – Flashing green LED provides positive indication that pilot is on.
Horizontal and Vertical Venting – With 3″ or 4″ PVC, ABS or CPVC (Maximum equivalent vent length on reverse side).
2″ Non-CFC Foam Insulation – Covers the sides and top of tank to save energy by retarding loss of heat. Also increases jacket rigidity.
Water Connections – 3/4″ NPT factory installed true dielectric fittings.
Factory Installed Heat Traps – Design incorporates a flexible disk that reduces heat loss in piping and eliminates the potential for noise generation.
Protective Magnesium Anode Rod.
3/4″ NPT Side Connections.
Pedestal Base.
T&P Relief Valve – Included.
Brass Drain Valve – Durable tamper proof design.
